whats the limit for weight on that i am near 240 ! i am wanting to get into snowbording and no nothing about it.

scott its becker i want this sent pm on junktex!

nice ! i think i am going mega squirt,  how is sds for 1st time start up?

well that wasn't posted by me.

my  gti drives really  nice dumped, i got poke all the way around with 13x8's about less then 1/2 inch of space between fender and tire , and no modafied fender wells. sitting on vmaxx coils . only rubs a very small bit when in a real tight corner, but never was enough to blow me out.never ruined any tires. was a complete pig to get on and adjust on the alignment rack. had to buy  camber bolt for the fronts.

the pan took some shots , so i took 1/4 inch steel diamond plate and plasma cut it and mig'd her on all the way around.
held up real nice, cuz no matter how alert you may think you are ,there allways that one intersection,where there are indented trackter trailer lanes where its real high centerd and you will scrap up good getting out of the way to safety.I enjoy a nice dildo in my ass

that is a sweet ass set up!
what standalone were you going to run? mega squirt?

25,000 miles on a rebuilt 2L bottom end,18L 16v head with mild porting. car made 141 to the wheels and ran 14.90.
full swap comes with 16v peloguin 020 trans with oem gearing .new stage 2 spec pressure plate with clutch net 6 puck sprung clutchdisc with a new light wieght euro flywheel.also come with
tank pump,and fuel box/pump ,all wiring eco knock box,                  tt fuel inrichment and fuse box included .also fuel dizzy lines injecters . cooling hoses,raideator /fan. starter. oem down pipe and exhaust manifold. new distributer and neuspeed wires ,bosch coil.speedo cable, throttle cable,clutch cable. etc, basiclly everything but axles.
at time of rebuild the head got....
tt euro cams
mk3 lighter lifters
tt high rev valve springs
all new gaskets
water pump
fan switch low temp
thermo stat low temp
cap
rotor
plugs
neuspeed wires
the bottom end got....
oil pump
main bearings
thrush bearings
rod bearings
honed
rings
balanced crank
micro polished crank

would the hole swap to go to one person,weather to put in a mk1 or mk2 or what ever.

if you want to buy it out right $1,400$ neighborhood to start

would trade for a vr swap or vr parts or rare or neat euro mk2 trinkets and cash or trade for a car or what ever what do you got lets make a deal, i want this out of my garage.

will take pics tomorrow in the day light!

good times!

2nd or 3rd this state ment!

want 4 nice size or becouse of size 3 big meat cleavers with gold chrome,wood handles and blood! got to find a shop and get er did!

if it has the original tran it has a 4:25 r&p to make someones day aloy better! and the turbo systems is worthe 4-6 depending on how nice the parts are , if you part it!i say a good buy indeed!

least it wasnt sac hair!

i was there for some of the action! good times!

i love mine  its a big time improvement over 10 years of nextel!!!

the hole pics and comments are funny