|
Title: obd-2 simulator? Post by: carsluTT on May 14, 2008, 07:15:43 AM so i was looking at this web site and i had a idea, could i put something like this into my car so when i go in for inspecton and they scan my car there isnt any probelms for me to worry abut?.........
http://obd2cables.com/products/ have a lill baord up in the dash w/ a obd-2 plug hooked to it, so that when billy dip shit inspecton guy go's to scan my car it reads all clear even tho im runing standalone?........ Title: Re: obd-2 simulator? Post by: dreadlocks on May 14, 2008, 08:32:32 AM depends on if these things also simulate the readyness status, because I believe thats all they check..
would be pretty easy to detect you had it wired in there, because speed, rpm, time since start, etc will all be obviously wrong if they decide to look at any of those values.. but then again you could get some kinda electronic potomoter and do some nifty electrical engineering hacking the hell out of it to hook outputs from your standalone into the simulator, and out the OBDII protocoll.. hrmmmm Title: Re: obd-2 simulator? Post by: carsluTT on May 14, 2008, 10:59:18 AM that sounds like a bunch of work, how bot i tape a 20 to my dash and hope they go for it
Title: Re: obd-2 simulator? Post by: need_a_VR6 on May 26, 2008, 08:36:49 PM I have gotten an OBD2 ABA ecu to have no codes on the bench simulating but it was a whore. There's no way I can make it pass readiness or do anything else. Shit's too smart and without recoding the shit out of the ECU that's about it for me.
|